R-253-e

                    M A T E R I A L - D A T A S H E E T

R-253   W A X - R E M O V E R

Brief instructions :                                   01.01.10
Turn off the floor heating the day before treatment.
1.) Apply the Wax Remover generously using the Z-855 brush. Leave for 10-60 minutes.
2.) Brush the entire surface and thoroughly rinse twice with clean water.

Contents:
Ester, d-limonene, alcohols, emulsifying agent.

Application:
Use a gas mask with a solvent filter in closed premises. Wear solvent-resistant shoes. Apply the Wax Remover with a watering can and distribute in a thick, even layer using a large brush (Z-855 Brush).
Leave the Wax Remover on for approx. 10-60 minutes depending on how dirty the surface is. Check from time to time on the state of the surface so that the Wax Remover and the dissolved dirt can be removed at the right time. Thoroughly rinse twice with clean water and a brush.

Technical data:
GGVS: cl 3.31 C
Inflammable according the VbF All standards.
Application temperature: > +5°C
Dry storage: +5°C minimum.

Indications:
The Wax Remover causes dark spots to appear on the surface which may not dissolve completely for several weeks.

Safety in the work place       environmental protection:
The product contains solvents that cause temporary dizziness if inhaled, which is why a gas mask should be used in closed premises.
Small residual quantities in the tin should be left to dry up completely; the resulting solids can then be disposed of along with the household refuse. The tins should be taken to recycling units.
The treated surfaces are physiologically harmless after the solvents have dried.

Storage stability:                 Coverage:                      Drying time :
approx. 1 year                    approx. 100 g/m²              approx. 10 minutes

Our directions for use are only general recommendations to be checked on site for each specific use.

back