R-275-e

                 M A T E R I A L - D A T A S H E E T

R-275   G R A N I T E - C L E A N E R

Brief instructions :                                   01.01.10
Take care when using on copper and sheet metal flashings !
Respect acid protection regulations !
1.) Pre-humidify the stone slightly.
2.) Apply Granite Cleaner undiluted or diluted (up to 1 : 10). Do not let it dry on the stone!
3.) Rinse thoroughly twice using a brush and clean water.

Features :
Cement residue, grit and grinding dust and slight traces of rust on granite surfaces are completely eliminated with R-275 Granite Cleaner.

Contents :
Anionic/non-anionic tensides, phosphoric acid, aromatic substances.

Conditions for use :
When using the Granite Cleaner on site, metals (in particular copper and galvanized sheet iron) must be protected, since the Special Cleaner attacks these metals resulting in extensive oxidation.

Application :
Pre-humidify the stone slightly then apply the Granite Cleaner in a thick coat.

Never let the Granite Cleaner dry on natural stone     even more specking will result !
Wet the entire surface with clean water to wash off the Granite Cleaner, scrub the surface with a brush and remove any remaining dirt and cleaning product by suction.
The rinsing procedure must be carried out twice.

Defects after application :
If yellow spots appear on the natural stone area after cleaning, it is because the Granite Cleaner has been left to dry on the surface!
In this case, the cleaning procedure must be repeated. Let the Granite Cleaner react on the surface for a certain amount of time while being careful not to let it dry.

Indication :
In order to ensure greater protection of granite surfaces, the stone should be impregnated with I-234 Stain Stop after several days of curing (depending on the moisture content and the weather conditions).

Safety in the work place     environmental protection :
The product contains slightly bio-degradable acids.
Respect acid protection regulations!
Empty tins can be disposed of with household refuse.

Storage stability:                 Coverage:                      Drying time :
approx. 3 year                       approx. 50 g/m²             approx. 30 minutes

Our directions for use are only general recommendations to be checked on site for each specific use.

back