H-606-e

                    M A T E R I A L - D A T A S H E E T

H-606     D E N Z E L - S T O N E - I N J E K T I O N
for light and white coloured stones with cracks.

Brief instructions :                                   01.01.10
Features :
Sticks cracks in stone.

Preparation :
Warning: On white and "soft" types of stone, a dark strip may occur in the crack area !
Test the product first in an inconspicuous area !
Through cracks have to be sealed from the rear in order to prevent the resin from seeping out.

Application :
Hold the cartridge in upright position. Unscrew the cap. On injection kits that have already been used, the holes have to be cleared using a small screw driver.
Do not cut off the tip of the mixing nozzle. Screw on the mixing nozzle.
Place the cartridge in the applicator gun, squeeze out a small quantity of resin and discard.
Apply a thin ribbon of adhesive to the crack.

Unscrew the mixing nozzle. Let remaining product harden. Dispose via household refuse.
Hold the cartridge in upright position. Wipe the top with a cloth and screw the cap back on.
Allow the resin to cure for approx. 1 hour at 20°C. Once it is half-cured, carefully cut off any excess resin with the blade supplied. Resanding and polishing may thus possibly be avoided. Low temperatures will prolong the curing process !
Curing may be accelerated by warm air at approx. 50°C.

Safety data :
H-606 Resin Injection Kit is composed of epoxy resin and an accelerator.
When in contact with the skin, immediately rinse with plenty of water and soap.

Disposal :
Push the resin through the mixing nozzle, allow to cure and dispose with the household refuse.
Storage:
at > +10°C
Our directions for use are only general recommendations to be checked on site for each specific use.

back